TPE Through Wall Outlets (Ribbed Flange)

Select regional version:

Download

The object content is configured for use in UK, but it may also be suitable for use in other locations.

Tags:

Preformed drainage outlets manufactured from TPE compound for through walls and drainage holes next to parapets using bitumen based waterproofing membranes. Most suitable for liquid two-coat bitumen, felts and hot melt.

These TPE through-wall fittings are an alternative design and manufactured with a ribbed rather than perforated profile across the whole flange/border. Apply one coat of waterproofing membrane and install the outlet. Allow the still tacky membrane to ooze through the perforations and then apply the second coat of bituminous membrane to achieve an over-and-under bond.

Drainage outlet is protected by having additional layer and fully sealed. A round or square leaf guard can be inserted into mouth of outlet once installed. Always use a compatible primer both to the outlet shape and the waterproofing membrane before installation.

Platform Compatible Version Certified to
IFC IFC - 1 2.1
Revit Revit 2017 + 1 2.1

  • Properties and values
  • More BIM objects

Properties and values

IFC
IfcExportAs
IfcWasteTerminalType
IfcExportType
NOTDEFINED
COBie
BOS_General
NBS_Data
AngleFace
45° angled face type which aids water runoff
HeightOfTheFlangeAboveTheOutletHole
160 mm
HeightOfTheOutletDrainageHole
65 mm
ImstallationGuidance
Installed in a sandwich technique where unit is heat bonded with direct flame to allow liquid bituminous membrane, becoming tacky and oozing through perforations to bond to second layer. Can also be fitted using mechanical fix or bond using solvent adhesive - always prime both outlet and surface
InnerLengthOfTheOutletPipe
425 mm
InstallationGuidance
Installed in a sandwich technique where unit is heat bonded with direct flame to allow liquid bituminous membrane, becoming tacky and oozing over top of flange to bond to second layer installed across the mouth of the spigot, can also be fitted using mechanical fix or bond using solvent adhesive - always prime both outlet and surface
IntegralAccessories
Gravel excluder, leaf guard
TheWidthOfTheFlangeAcrossTheFace
340 mm
WidthOfTheFlangeInFrontOfTheOutletHole
150 mm
WidthOfTheOutletDrainageHole
100 mm

More BIM objects