Rada V10 Concealed Shower Valve

Select regional version:

Download

The object content is configured for use in UK, but it may also be suitable for use in other locations.

Tags:

Built-in, single sequential thermostatic shower valve. Supplied complete with integral strainers and optional flow regulators.

Platform Compatible Version Certified to
IFC IFC - 1 1.3
Revit Revit 2016 + 1 1.3

  • Properties and values
  • More information
  • More BIM objects

Properties and values

IFC
IfcExportAs
IfcValveType
IfcExportType
MIXING
COBie
NBS_General
NBS_Data
ConnectionInlet
15 mm Compression
ConnectionOutlet
½201D BSP Flat Face / 15 mm Compression
ConnectionStandard
Hot: Left, Cold: Right, Outlet: Bottom or top
FlowRateManufacturerNote
At supply pressures > 0.5 bar, we recommend fitting the 9 L/min flow regulator. For increased water saving the 6 L/min flow regulator should be fitted (both supplied)
FlowRateMaximum
30 L/min (achieved at 1 bar pressure loss across the valve with flow regulators removed
FlowRateMimimum
3 L/min (at nominally equal pressures)
Form
Concealed wall mounted thermostatic shower mixer valve
Operation
The Rada V10 is operated via a single sequential control which when rotated initially opens the valve, then increases temperature from cold, to a pre-set maximum
PressureManufacturerNote
Both hot and cold pressure should be nominally equal
PressureMaximum
5.0 bar
PressureMaximumPressureLossRatio
Should not exceed 10:1 in favour of either supply during flow
PressureMaximumStatic
10.0 bar
PressureMinimum
0.15 bar
TemperatureControlManufacturerNote
In the event of loss of either supply, the valve will automatically shut off
TemperatureControlMinimumBlendTemperatureDifferential
12°C to either supply
TemperatureControlTemperatureMaximum
Factory set at approximately 41°C, but this can be reset on site if required (by an authorised person)
TemperatureControlThermostaticControl
±1°C within the range 35°C to 45°C (assuming supplies of 15°C cold, 65°C hot at nominally equal pressures)
TemperatureRangeColdWaterRange
5°C to 20°C
TemperatureRangeHotWaterRange
55°C to 65°C (recommended)
TemperatureRangeManufacturerNote
For reasons of general safety, hot water storage temperatures should be maintained at between 60°C to 65°C where serving ablutionary applications. The mixing valve can accept temporary excursions above 85°C without damage, however operation at such elevated temperatures is not recommended
ThirdPartyCertification
Buildcert TMV2 Scheme Approved, WRAS Approved
WaterSupplyTemperatureMaximum
85°C
Pset_ValveTypeCommon
Pset_ValveTypeMixing

More information

More BIM objects