Select regional version:
The object content is configured for use in UK, but it may also be suitable for use in other locations.
| IfcExportAs |
|
IfcValveType |
| IfcExportType |
|
MIXING |
| ConnectionInlet |
|
½201D BSP external union or 15 mm compression (nut and olive not provided) |
| ConnectionOutlet |
|
½201D BSP external union or 15 mm compression (nut and olive not provided) |
| ConnectionStandard |
|
Hot-left, cold-right, top outlet |
| FlowRateMaximum |
|
35 L/min |
| FlowRateMimimum |
|
3 L/min at mid blend |
| Form |
|
Built-in Valve |
| Operation |
|
Rada 215-t3 series mixing valves do not have integral flow control; appropriate provision must be made for this in the outlet pipework. This can be in the form of basin/bath tap, stopcock, mechanical timed-flow controller or solenoid. The device chosen must be non-concussive in operation |
| PressureManufacturerNote |
|
Both hot and cold pressure should be nominally equal |
| PressureMaximum |
|
5.0 bar |
| PressureMaximumPressureLossRatio |
|
10:1 (in favour of either supply) |
| PressureMaximumStatic |
|
10.0 bar |
| PressureMinimum |
|
0.15 bar |
| TemperatureControlManufacturerNote |
|
In the event of loss of either supply, the valve will automatically shut off |
| TemperatureControlMinimumBlendTemperatureDifferential |
|
12°C to either supply |
| TemperatureControlTemperatureMaximum |
|
Factory set at approximately 41°C |
| TemperatureControlTemperatureMinimum |
|
1°C |
| TemperatureControlThermostaticControl |
|
35°C to 50°C |
| TemperatureRangeManufacturerNote |
|
For reasons of general safety, hot water storage temperatures should be maintained at between 60°C to 65°C where serving ablutionary applications. The mixing valve can accept temporary excursions above 85°C without damage, however operation at such elevated temperatures is not recommended |
| ThirdPartyCertification |
|
Buildcert TMV3 Scheme Approved, WRAS Approved |
| WaterSupplyTemperatureMaximum |
|
85°C |
IFC
Revit
